SOHC.co.uk Forums > CB350/400

Cb400f Clutch basket rubber cush drive

<< < (7/9) > >>

amx1992:
I got my Viton from this place, but sit down when you look at the price of a sheet

https://www.coruba.co.uk/black-high-temperature-fkm-rubber-sheeting-75-shore/

Oddjob:
Already seen that Max but I can't find the small strip you appear to have bought.

I've found some in China but it's £267 for a 500mm x 500mm sheet, far more than I would need.

amx1992:
Be wary with any from china, i bought a bit and when it arrived i checked the density and it was nitrile or something similar, not viton. I had to message them to get a price for the strip

Oddjob:
I've emailed Dennis Winter to see if any of his will fit, will let you know if and when they respond.

Oddjob:
I wonder if anyone on the forum can do a CAD file for the damping rubbers, I'm talking to a water jet cutting company near me about doing some for me. The only problem is the diameter of the cutting head is 1mm so there is a 0.5mm difference which I suppose would need to be factored in.

I'll have to see about opening a CB500K clutch basket and seeing if they are the same as the CB550F, I'd imagine so but it's best to check beforehand.

Just done some quick calculations, a 1000 x 1200mm sheet of 10mm Viton is around £900. That would produce approx 1470 of the small discs, depending on wastage etc so say 1400. That approx 233 sets of damping rubbers, which makes each set cost approx £4, so it depends on how much it costs to cut the dammed things. Correct me if my maths is wrong.

Navigation

[0] Message Index

[#] Next page

[*] Previous page