SOHC.co.uk Forums > CB350/400
Hello All..new to the forum and new to bikes..400 4 Carbs overflowing..
K2-K6:
I'm not sure if this will be suitable for your timescale and don't know if they are still going but:- there was a company called "PRECORIL Seals" in Frimley that I've bought o-rings from to my spec years ago and they just seemed to specialise in this stuff. I lived near there and just went in with examples that they matched so they don't specifically do bikes but in depth application of seals.
Will be going past there this week so will look them up if I can't find on www.
vivvov:
Thanks K2-K6
googled them but no luck. I'm East London..must be some small shed with all the O Seals ever made, somewhere Stratford CanningTown way..I'm going to drop by a motor factors I know who've always been helpful and see if they have any idea.
Vivvov
Bryanj:
Most Hydraulic repair people will have "O" rings its just wether the size is a standard or a B*****D size
K2-K6:
Was working on an XR 500 Honda years ago and couldn't identify sizing on a bolt in the head, turned out to be 9mm........yes nine!! only one I've ever seen.
You may be lucky to get a straight match off the shelf, if so I'd buy a spare set as well.
marineboy:
Hi,
If my memory serves me correct (and it probably does not!) Dave Silver does a complete float needle valve for about
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version