SOHC.co.uk Forums > CB500/550

Planning ahead - fitting the primary drive unit back in place'

<< < (8/9) > >>

Oddjob:
They don't show pitch size Ted unless it's non standard as a rule. There is usually at least 5mm of thread unused in a standard Honda tapping, so it's ok to use 150mm in a 145mm hole for instance, use a thicker washer and bed it slowly, just in case, you can always trim it down if it's too long in the end. 35mm for 32mm is what I use.

Oddjob:
6 and 8mm bolts that Middleton sells fit the 500 in all locations. It's only the 10mm and higher bolts that need metric fine. The engine hanger bars for instance, the ones at the back of the engine are threaded metric fine so need metric fine nuts to suit.

Bryanj:
Oh come on Ted,
Whitworth
BSF
BSP
BSB
BSC
GAS
PIPE TAPER
BA
and thats not all

McCabe-Thiele (Ted):
Not forgetting Chains, Furlong, Rod, Peck & Bushels Bryan.😁😁😁

Not to mention the Gill - I think it is still a legal whisky measure today that defines a shot.

Bryanj:
Yup, but i was just talking thread forms/pitches

Navigation

[0] Message Index

[#] Next page

[*] Previous page