SOHC.co.uk Forums > CB750
Clutch plates
Trigger:
So you have a K2 clutch that was fitted to the UK K2 from 1972 to 1974 .
Your bike must have been registered in 1975 but, was it manufactured in late 1974 ? If so the clutch components you have in the picture are correct.
Trigger:
Now we are getting somewhere. Your springs should be 35.50 mm to 36.00 mm in length and those steel plates need a good clean, if you haven't already done so. ;)
Pauarc:
Before I fitted new plates I put the steel plates in a ultrasonic cleaner springs are new
Trigger:
The steel plates have a covering of dimples, these dimples trap oil and need to be very clean.
Did you put all the steel plates in with the flat side to the engine and the beveled edge facing out ?
Just because the springs fitted are new, there are two types so, you need the correct length ones as mentioned before ;)
Pauarc:
I just checked the old ones they are 31.5 mm the new ones are 31.9mm I made a note and yes flat side in and bevelled side out.
this is the length off springs in the manual I have
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version