SOHC.co.uk Forums > CB750
Clutch plates
Pauarc:
I have just set central nut as you suggested have not tried yet as out today
K2-K6:
Some good details and specifications there from Graham.
Adjustment looks reasonable from arm position, it's just trying to bring maximum lift that can be attained with the lever/cable etc by adjustment to very small gaps in each stage.
Lever end free movement is in the manual at 10~25 mm, with that set to minimum @ 10mm it should reach the largest lift space possible on the plates/clutch pack and give the least drag in operation.
Trigger:
--- Quote from: K2-K6 on June 30, 2023, 11:52:01 AM ---Some good details and specifications there from Graham.
Adjustment looks reasonable from arm position, it's just trying to bring maximum lift that can be attained with the lever/cable etc by adjustment to very small gaps in each stage.
Lever end free movement is in the manual at 10~25 mm, with that set to minimum @ 10mm it should reach the largest lift space possible on the plates/clutch pack and give the least drag in operation.
--- End quote ---
There is something strange going on. I have built a shed full of K2 clutches over the 32 years in the engine business and it is one of the easiest ones out of the 750 range. ;)
Pauarc:
If the fin washer is missing behind basket could this effect the clutch I can’t remember seeing it
Trigger:
I would not know as i have never fitted a clutch without one. It is listed as a thrust washer 90458-506-810 ;)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version