Other Stuff > Misc / Open
Measuring O-Rings
Oddjob:
Never seen the orings for the head in green, the valve stem rings were green though. One of the 11 x 2.5 rings is for the tacho drive but not sure without looking where the other 2 are used.
Small one doesn't belong. Looks like a carb ring.
Tappet covers are 30.8 x 3.2mm.
the 2 oil control valves are the bottom of the barrel for the other 2 x 11 x 2.5mm rings.
Looks complete Ash. Missing the valve stem seals you get in a genuine kit though unless you didn't show them as they aren't orings.
Bryanj:
Cam chain adjuster bolt i think, the top one has a crush washer the adjuster an O ring under the normal washer, check the size in the 500 book in cave
Oddjob:
The camchain adjuster is the 5.8 x 1.9 one.
AshimotoK0:
'O" rings are from the kit you kindly sold me when I 1st bought the bike off James, Bryan .. the complete one with the yellow cardboard packing. It didn't include the stem seals..so I bought those separately online and are already fitted. I also got a genuine bottom end set a year or so later in a job lot of gasket sets (already detailed earlier in this thread).
Bryanj:
Still got some of those for mine, didnt realise there were no stem seals, sorry Ash.
Stumped about the O ring then, cant think of any other small ones
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version