SOHC.co.uk Forums > CB350/400

Main bearing and primary guides advice

<< < (7/9) > >>

Oddjob:
There is a chart in the workshop manual and the parts book which you use the markings you listed to work out the correct shell size. Not green shells, too small. In order of thickness it goes on the 400, blue, black, brown, green, yellow, red. You could fit blue and just run it in slowly, black is the correct size but brown is a size under the correct size but at a real pinch you could use those. I was told by a Honda trainer it was ok to go up or down a size but not down 2. Ideally not up 2 either but at least the excess will wear away with a good running in..

I would suggest a polish would make the gap bigger as well. Plus for the cost of that just buy another crank, try and find one with the markings visible and ideally with the letters B on the crank journals not C. I doubt your engineer friend knows how fine the tolerances are on Honda cranks or he'd have agreed the crank is past it's best. Price up another crank, it's probably for the best.

davidcumbria:
Here is the link I used for my 550 shells from Japan
https://en.impex-jp.com/catalogs/moto/honda-other/cb550/cb550k-a-1976-usa-6724/camshaft-crankshaft-455707.html

Fleabie:
Hi all,

Thanks for all the previous advice. It's all been very useful.

Well after much hunting I found some 'new' blue main shells. I could not get hold of the black ones for love nor money. So I have had to go up a size, which by all accounts is safe to do, as long as you run it in sensibly. I say 'new' because these shells are not in original Honda packaging but they have been carefully labelled with the correct part code in hand writing. I can also see the blue dot of colour on their sides, so that's very reassuring. So fingers crossed, they are what they have been sold as. I am going to clean up my case and check the shells with plastiguage.

The shell's look 'new', but they have horizontal marks across them i.e. perpendicular to the direction of rotation where you would expect to see marks on shells that have been used. Attached are 3 pictures of just one 'new' shell. Perhaps they have been tested in a crank case, and then found to be not suitable? But I would not expect a new shell to have any blemishes. The blemishes seem light enough to me but just want to check in with the experts :-) N.B. As before, these images greatly exaggerate how they look in real life ! Please bare that in mind when viewing the images. Is it normal for new shells to have these blemishes?

Thanks in advance!

Nurse Julie:
Typical New old stock that haven't been stored in the original brown oiled paper.

Bryanj:
Yup, bad storage

Navigation

[0] Message Index

[#] Next page

[*] Previous page