SOHC.co.uk Forums > Project Board

cb 500 but not to standard

<< < (6/9) > >>

Nurse Julie:
As discussed Gary.

[ Guests cannot view attachments ]

[ Guests cannot view attachments ]

gary123:
Thanks Julie.

Trigger:
Have a load of the rubbers Gary but, i have two different types at different lengths. I know one is 500/550 F1,F2  the others are 550K3 but can not remember which is which mate. Do you have the old ones to measure up ?



  [ Guests cannot view attachments ]



The two different lengths. As you can see mate, the end ones are taller .



[ Guests cannot view attachments ]  

gary123:
[ Guests cannot view attachments ]

The distance from manifold to ruler edge is 24mm if this helps.

Trigger:
Look at the second picture and you will see the end two are slightly higher. The picture is of the middle ones that fit 2&3.

Sent you a PM mate

Navigation

[0] Message Index

[#] Next page

[*] Previous page