SOHC.co.uk Forums > Project Board
Doms CB550F1 project
Trigger:
--- Quote from: DomP on September 02, 2023, 10:30:17 PM ---I quite like the idea of a bit of cam reprofiling, if I find everything else to be in good order I may go down that route. In terms of top end gasket and o-ring kits, where is best to get them?
--- End quote ---
Vesrah are a top kit and you will need more than a top end set ;)
DomP:
I've got it stripped down and barrels off, I think at this point pictures will speak a thousand words, some good, some not so. Here goes, I've not got a valve spring compressor so that bit will have to wait.
DomP:
There's more
DomP:
Apologies for the picture heavy content!
Cylinder 4, the small end bearing has some wiggle but the rest all seem fine from my very basic checks, all piston rings were free but the barrels don't look great do they?
DomP:
Things I've noticed are the pitting on 3x tappet adjuster screws, some rough and raised edges on two of the puck recesses, pitting to the valve side of the head, the bores are a little scored and one has an inclusion or something.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version