SOHC.co.uk Forums > Project Board
Doms CB550F1 project
Trigger:
I had a shed load of carb body's that i cleared out last year. Julie put them on ebay and sold all within a month.
Most owners damage (Snap off ) the float pin towers trying to get the pin out. I have always found that if, they are well stuck in. It is easier to run a thin blade down the side of the towers and cut through the brass pin. Cheaper to replace a in than a carb body ;)
Hope you get a result .
DomP:
Amazingly the Ebay seller of those carbs is unwilling take the bowls off to enable me to check the condition.
McCabe-Thiele (Ted):
--- Quote from: DomP on August 13, 2023, 02:40:38 PM ---Amazingly the Ebay seller of those carbs is unwilling take the bowls off to enable me to check the condition.
--- End quote ---
That might be because he knows they are not very good inside.
Nurse Julie:
--- Quote from: DomP on August 13, 2023, 02:40:38 PM ---Amazingly the Ebay seller of those carbs is unwilling take the bowls off to enable me to check the condition.
--- End quote ---
Well, that's a poor show, they probably have no internals in them 😂😂😂
Seabeowner:
--- Quote from: McCabe-Thiele (Ted) on August 13, 2023, 03:28:08 PM ---
--- Quote from: DomP on August 13, 2023, 02:40:38 PM ---Amazingly the Ebay seller of those carbs is unwilling take the bowls off to enable me to check the condition.
--- End quote ---
That might be because he knows they are not very good inside.
--- End quote ---
Equally amazing they sold in a day. Did you buy them?
If they were listed as used, they must be serviceable. But just looked they are just marked pre owned, so maybe anything goes.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version