SOHC.co.uk Forums > Project Board
Doms CB550F1 project
Trigger:
--- Quote from: K2-K6 on September 07, 2023, 05:37:51 PM --- :o Oh no, not thread pitch again ;D
[/quote
;D ;D ;D ;D
--- End quote ---
Oddjob:
Just checked the Honda tool and they are all 1.5 pitch, the arms are marked 16, 18, 20, 22.
Check the bolt supplied to be 100% sure that's 1.5mm and they've not sent something else by mistake.
DomP:
I'll blame the bolt I got from my local tool hire shop, it cost me nothing as they couldn't be bothered to charge me for it.
Trigger:
--- Quote from: DomP on September 07, 2023, 06:12:08 PM ---I'll blame the bolt I got from my local tool hire shop, it cost me nothing as they couldn't be bothered to charge me for it.
--- End quote ---
You can not any old bolt, if it snaps you will have another problem. The bolt needs to be high tensile and that is why a car wheel bolt is ideal ;)
Seabeowner:
I used a bolt from a Fiat van. Got the end turned down like the real tool. No impact, so tighten, hit with mallet, tighten, hit with mallet and they pop off.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version