SOHC.co.uk Forums > Project Board
Doms CB550F1 project
Bryanj:
By pins i meant crank pins i.e. big end and mains, sorry i was talking machinist!
Bryanj:
Forgot to say if you do want to reprofile the cam i have i just picked up from a member in cheltenham who is leaving for portugal and it has slight wear on one lobe so ideal to send away and keep your standard one if in good nick
Oddjob:
I asked Newman cams if they could reprofile a rocker arm and they said yes, they hard chrome them then grind back to original shape, never knew they did that.
Trigger:
I would strip the crank down to clean out all the traps as that sealant gets everywhere. Once all cleaned, plasti to see if any of the shells are worn. If it is to spec, you should be good to go with the crank and rods ;)
DomP:
I'll strip the crank tomorrow evening once I've ground a socket down to fit the conrod nuts, im concerned the small end on cyl 4 conrod might be worn, it feels looser tha the other three.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version