SOHC.co.uk Forums > Project Board
Doms CB550F1 project
Trigger:
Yes, back to standard spec. And you have to do all the rods the same to keep the weight right ;)
Seabeowner:
Plastigage is cheap. But if you measure out of spec with the clearances and if you can't rely on the crank being as new then you have to buy (or borrow) a pair of new shells to do the measuring with.
DomP:
I've spent the morning plastigauging my crank, the results are very consistent. I won't bore you with every journal but they are to my eye identical across the entire crank, an enjoyable process!
Bryanj:
Cant remember spec, is that within?
DomP:
--- Quote from: Bryanj on September 16, 2023, 04:54:00 PM ---Cant remember spec, is that within?
--- End quote ---
Haynes says 0.02 to 0.048
My readings were when torqued to the lower end of the range
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version