SOHC.co.uk Forums > Project Board
Doms CB550F1 project
Oddjob:
The tensioner ring is 5.8 x 1.9mm Dom. Should be in the kit. Measure how thick the head gasket is first.
I can supply rings for the oil pump if you need them.
Will look for that lock washer etc tomorrow
DomP:
I've ordered new bearings for the selector drum and primary shaft, two are easily removed but one on the primary shaft is really on there. I think I've read Ken saying it can be rested in a loose vice and the shaft carefully tapped through, have I understood this correctly?
Oddjob:
Spot on, just open the vice wide enough for the shaft to move and tap the end.
DomP:
Thanks Ken, I was just surprised it was such a tight press fit compared to the other end
DomP:
How much force is needed to get the bearing off? I've smacked the hell out of it, any more and I risk damage to the shaft end. The bearing hasn't budged but is now probably not in great condition
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version