SOHC.co.uk Forums > Project Board
Doms CB550F1 project
Oddjob:
All mine just fell off Dom. Try some heat and see if that helps. I have a few of the shafts if you bugger it up.
DomP:
--- Quote from: Oddjob on October 04, 2023, 04:31:07 PM ---All mine just fell off Dom. Try some heat and see if that helps. I have a few of the shafts if you bugger it up.
--- End quote ---
I'll get my mapp gas on it Ken
DomP:
Bingo! Got it hot and off it popped with a big whack Ken, I tapped the new one home using a 21mm deep socket and then the last bit with an old 6205 bearing as a spacer to get the extra depth needed that the deep socket didn't have. I think that makes sense but essentially a success.
DomP:
Yesterday I travelled to Bryan to pick up my .5mm rebored barrels, I assembled the bottom end when I got back using what I thought was the thinnest layer of Hondabond, maybe it was due to my garage being pretty cold but it was near impossible to brush on. I ended up dabbing it on with my finger to get a thin covering. When I torqued all bolts down I got a small amount of sealant squeeze out which is now concerning me, in my haste, ok it was excitement, I missed to hondabond the two crank end seals. Do I need to split it an do it all again?
Bryanj:
Nope, it should be ok as long as case uo to edge of seal was done, seals are slightly oversize so should clamp ok.
As to sealant squeezing out a small amount is ok
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version