SOHC.co.uk Forums > Project Board
Doms CB550F1 project
McCabe-Thiele (Ted):
I believe Hammerite Smooth will pretty much stick to anything so if out of view shading might not matter
DomP:
--- Quote from: McCabe-Thiele (Ted) on November 07, 2023, 09:24:07 PM ---I believe Hammerite Smooth will pretty much stick to anything so if out of view shading might not matter
--- End quote ---
I think I'll get it out in natural daylight to make a decision, if it stops raining!
Bryanj:
It used to, but like a lot of the good stuff its been altered and aint so good anymore
DomP:
--- Quote from: Bryanj on November 07, 2023, 10:11:15 PM ---It used to, but like a lot of the good stuff its been altered and aint so good anymore
--- End quote ---
Combicolour is really good Bryan, flats out even when brushed on which is one of its claims, even better if you warm it and the workpiece while using it. It does claim to be ok over powdercoat as its recommended for industrial use on machinery etc. I'll do a bigger test patch I think then give it the scratch test!
DomP:
Yesterday I bit the bullet and lopped off the rear seat bracket to weld in my upswept hoop, I've not done much welding but nothing watching a few YouTube videos couldn't sort. I've noticed another peculiarity with my right foot peg, it's an F so has the fold up peg but when down the rubber sits sloping forward rather than being horizontal like the left side, could it be a peg from another model? It looks identical to the parts fiche on CMSNL.
A bit of a side note but I've noticed my frame and engine numbers match, I thought this rarely happened and given the mix up of parts on my bike I'd assumed the engine may not be original.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version