SOHC.co.uk Forums > Project Board
Doms CB550F1 project
DomP:
--- Quote from: Oddjob on November 14, 2023, 04:48:19 PM ---Try turning the peg down on the bolt
--- End quote ---
In this photo you can see that it's located in the notch on the frame so won't rotate any further, the other way would be the wrong direction so i can only assume it must be the wrong peg for this bike
Bryanj:
I am probably wrong but i seem to remember the tand on the footrest bar locating againg the frame peg that sticks out
Oddjob:
Yeah, forgotten about that TBH Dom.
Footrest looks correct TBH. Special one fitted to the 550F due to the kickstart needing to fold right out to miss the standard 4 into 1 exhaust. It might be possible to fit the 500 footrest onto the lower bolt if you're not using the standard exhaust.
DomP:
--- Quote from: Bryanj on November 14, 2023, 05:58:11 PM ---I am probably wrong but i seem to remember the tand on the footrest bar locating againg the frame peg that sticks out
--- End quote ---
Yeah that's correct Bryan
andy120t:
I'm pretty sure I have the same on a 550f frame. Funny flip-up peg to avoid kickstart exhausts etc. with the peg in a different location to the K models. I assumed the foot rest was angled forward to give a sportier lean forwards towards flat bars on the F model.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version