SOHC.co.uk Forums > Project Board
Doms CB550F1 project
McCabe-Thiele (Ted):
Yours for postage only if you can use it. I will pop a photo up when I'm back home.
DomP:
--- Quote from: McCabe-Thiele (Ted) on February 03, 2024, 12:53:29 PM ---Yours for postage only if you can use it. I will pop a photo up when I'm back home.
--- End quote ---
Thanks Ted! I've tried searching the correct spacer sizes for a 550f1 but can't find much so I'm relying on what is fitted being correct, currently it is 38mm long x 34mm tapering up to 38mm x 20mm bore on the sprocket side, 50mm x 35mm x 20mm bore on the brake plate side.
If anyone with an f1 can confirm these I'd be grateful.
McCabe-Thiele (Ted):
The other measurements look the same as those you have posted for the hole size & thickness, bore 20 & 34-38 o/d diameter for the seal etc.
This spacer pushed my wheel off centre towards the right side so Max supplied me the correct one for my 500 that is about 3 mm shorter.
.
rear spacer by Macabe Thiele, on Flickr
DomP:
--- Quote from: McCabe-Thiele (Ted) on February 03, 2024, 02:00:46 PM ---The other measurements look the same as those you have posted for the hole size & thickness, bore 20 & 34-38 o/d diameter for the seal etc.
This spacer pushed my wheel off centre towards the right side so Max supplied me the correct one for my 500 that is about 3 mm shorter.
.
rear spacer by Macabe Thiele, on Flickr
--- End quote ---
Can I just check but it looks perfect Ted.
DomP:
Actually Ted I'll take it if I may, I'll message you.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version