SOHC.co.uk Forums > Project Board
Doms CB550F1 project
DomP:
--- Quote from: Johnny4428 on February 12, 2024, 12:28:27 PM ---
--- Quote from: DomP on February 12, 2024, 12:16:07 PM ---
--- Quote from: Johnny4428 on February 12, 2024, 11:26:56 AM ---Not that long ago I was groaning at them being £75! 😡
--- End quote ---
It's hard to justify £130 to the 'bank manager'
--- End quote ---
😂😂😂
An alternative would be plated ones on the front to match the rear? Would they be good enough to replate?
--- End quote ---
The DS ones are BZP aren't they, mine are too far gone and even then the tine involved plating 40 spokes and nipples with my small kit makes the DS ones price attractive
Johnny4428:
I tend to agree Dom, even with a set in good condition it would be quite a tedious job. Never done a set myself, just bought a replacement stainless sets. Time to talk the “bank manager!†😂
DomP:
Here's a question for Bryan or anyone else that knows the answer, I picked up a cb550 hub from Bryan last week which is the version without the flats on the speedo side, what is the real difference if any when used on a single disc set up?
Bryanj:
Single disc none at all, you use all the same bits in same places speedo drive is driven by the chrome plate and bolts
DomP:
--- Quote from: Bryanj on February 14, 2024, 01:53:31 PM ---Single disc none at all, you use all the same bits in same places speedo drive is driven by the chrome plate and bolts
--- End quote ---
Cheers Bryan, what was the change for then?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version