SOHC.co.uk Forums > Project Board
Doms CB550F1 project
Bryanj:
Probably cheaper to produce, less machinig time
DomP:
--- Quote from: Bryanj on February 14, 2024, 06:02:16 PM ---Probably cheaper to produce, less machinig time
--- End quote ---
OK, final question, what was the purpose of the machined flats that were seemingly not required?
Bryanj:
On the first CB 750 the speedo drive had two turned down flaps that engaged with the slots to turn the drive gearbox and the chrome trim was flat, aparently the speedo needle wandered due to not positive enough drive so honda modified it and i guess just did not get arround to altering the hub drawings till years later
DomP:
Thanks Bryan!
DomP:
Today is fork servicing and polishing day! I've had them all apart to find the lower tips of the stantions are worn a fair bit, I've never seem the. Like this before, are they toast?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version