SOHC.co.uk Forums > Project Board
Doms CB550F1 project
Trigger:
--- Quote from: Oddjob on August 24, 2023, 05:44:27 PM ---Thought the original spec was 180mm with a max spec of 181mm, which that drum clearly shows to be the same max spec.
Plus it's supposed to be the equivalent of the 42610-SB2-010 which you listed.
--- End quote ---
As i have already stated on this thread, you have to be careful of aftermarket drums. It needs to be 180mm spot on or like the old Honda ones were 179.850mm. The AP lockheed will be a tad over 180mm.
Try a Brembo 14.5069.10 or a Bosch 0 986 477 063
These were the last one i bought for Mick's and Roo's hub >>>https://www.autodoc.co.uk/brembo/1657868
Oddjob:
The specs listed show it as being 180mm. AP Lockheed are a decent make.
That Brembo one is mage expensive, especially when all you want is the liner.
Trigger:
Not expensive at £60 per drum. You get what you pay for.
My mate who is a window fitter had worn out his OEM brake disc's after 75000 miles on his van and he replaced them with cheap shite from europarts. They only lasted 10000miles ;)
DomP:
Before I commit to getting this hub relined, what's going on here with the alignment?
Oddjob:
Alignment Dom? Please clarify.
Correct me if I’m wrong here but weren’t AP Lockheed original equipment on some 750f models?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version