SOHC.co.uk Forums > Project Board
Doms CB550F1 project
Bryanj:
It does Ted
DomP:
I really haven't much to update on my project lately, I've been held up laying a brick plinth for my workshop build. I've tried to set up the magnetic speedo sensor supplied by Koso but can't get a reading yet. The speedo converter I got from Digital Speedos was definitely incompatible, attempts to contact them by phone and email have all been ignored so be careful using this company.
Hopefully I will have finished my brickwork by the end of next week so should be able to turn my attention back to the 550!
DomP:
I did something! My airbox had no lid or brackets to hold a lid on, thankfully Nige on here helped me out with a 550f lid so other than stripping and repainting it all I needed to do was make some brackets and weld some m5 threaded bar to them to locate through the lid holes. It's worked out really well so all I need to do is make a new seal and mesh the opening, the snorkel won't fit below mu home made seat base but I'm not sure it affects the running but is there more to prevent rain ingress...I could be wrong.
Top tip - remember to take the chuck key out of your pillar drill BEFORE turning it on! Chuck key still yet to be found.
Johnny4428:
Top tip - remember to take the chuck key out of your pillar drill BEFORE turning it on! Chuck key still yet to be found.
[/quote]
Thankfully it wasn’t imbedded in the soft tissue somewhere!😳
taysidedragon:
--- Quote from: Johnny4428 on July 05, 2024, 08:12:51 AM ---
Top tip - remember to take the chuck key out of your pillar drill BEFORE turning it on! Chuck key still yet to be found.
--- End quote ---
Thankfully it wasn’t imbedded in the soft tissue somewhere!😳
[/quote]
I hope that it didn't hit any bike parts on it's solo flight!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version