SOHC.co.uk Forums > Project Board
Doms CB550F1 project
Laverda Dave:
I remember during a metalwork class at school one of the kids was using auto feed on the lathe when he decided to go walkies. The resulting bang and carnage was a sight to see. The teacher went nuts and hit him over the head with a tool post!
Bryanj:
At college we had a large cardboard chuck key that the last person to leave one in had to wear until the next person did it!
DomP:
I'll cut one out and where it tomorrow Bryan!
I'm not sure what the airbox lid brackets should look like exactly but here are my efforts complete with front and rear stamps because they ended up slightly different.
DomP:
On the subject of filter lids, looking at photos I think the mesh aperture is around 2mm, can anyone confirm for me as it will surely make a fair difference in air flow restriction.
DomP:
Is this distance correct, I've read there should be a measurement of 56mm between cable nipple and cable anchor point but the diagrams are near impossible to interpret. What is the actual effect in real terms if the cables are not inder tension at idle?
The upper throttle stop screw into near to making contact with the bell crank
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version