SOHC.co.uk Forums > Project Board
Doms CB550F1 project
DomP:
Now I've solved the hanging idle problem I can move on to some of the minor niggles I have. Here is one that's baffled me, the right side cover doesn't fit nor does the resprayed replacement which is odd because the frame doesn't appear cut about, any thoughts folks?
Sesman:
Hi, Dom.
It may be the photo perspective, but something appears odd about that bracket position and associated welding. I’ve attached a few photos of my F2, which may be helpful…or not!
McCabe-Thiele (Ted):
It does not help that the lower photo showing the swing arm is upside down - unless that's me.
With three location brackets for the fitting holes can you not measure the distance between the two upper holes on the frame, then compare that measurement against the side cover locating pegs. This first measurement should help you point where the problem lies.
How doesn the diagonal measurement differ between the upper left hole and the botton locating one, how does this differ from the right side similar measurement.
Worst case scenario is there might be enough metal to file a locating hole in the right place.
Sorry if I'm stating the obvious.
Oddjob:
How about a pic showing the placement of all 3 holes?
The problem may be one of the others causing the front upper not to fit anymore.
DomP:
Thanks chaps, I'd not considered it being one of the other two brackets so ill get a photo of all three. That photo is the correct way up Ted
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version