SOHC.co.uk Forums > CB350/400
"Honda" seat logo
Athame57:
--- Quote from: Nurse Julie on September 02, 2023, 02:18:22 PM ---Yes George Piki is a forum member, he is also our forum sponsor 😂😂😂 His company, Redice, is at the top of the forum page. I'll get him to pop his head in this afternoon 😁😁😁
--- End quote ---
Thanks Julie! ;D
Mikep328:
Nice job, Julie! I'm not confident in my ability to duplicate it! ;)
Trigger:
--- Quote from: Mikep328 on September 02, 2023, 04:37:36 PM ---Nice job, Julie! I'm not confident in my ability to duplicate it! ;)
--- End quote ---
It is a lot easier than you think. You apply the stencil decal. Mask off around the area with newspaper to stop any over spray. Spray a very light coats at a time until it has built up and once dry remove all the masking tape and stencil.
If it doesn't look right, just wipe the paint off with nail varnish remover and start again ;)
philward:
I've also used the stencil from piki and the paint recommended by Julie on my 500 - as Trig advised, it's quite easy. I bought the seat cover with the Honda logo on for the 350 because I needed a cover anyway. Would have gone the stencil route otherwise
Sent from my moto g(50) using Tapatalk
Athame57:
Alas, I can't find this Honda stencil on the site. :(
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version