Other Stuff > Misc / Open

Anyone noticed that DK now selling parts vapour blasted?

<< < (2/2)

AshimotoK0:

--- Quote from: Athame57 on September 03, 2023, 10:50:11 PM ---It has got that rare chain guard the CB400F came with originally though. You could get one from DSS spares like that but at a price that probably put most people off. The one in the image here looks bashed about enough to have me wonder if it has been retro fitted?

--- End quote ---

Pretty sure its original just beaten up. Very hard to restore that guard as it was a very dark olive drab passivate zinc plate finish as far as I can tell.

I am just restoring one at the moment (from a 600 mile only bike but corroded a bit). Trying to get a decent finish without de-rivetting it.

K2-K6:
The chainguard just looks like it's  battered from incidentally being badly stored, and looks like someone has has a go at straightening with a pair of waterproof plyers.

The rivet on original aren't difficult to do Ash, you just need a "snap" set to match the dome so you can hit the other end and splurg it over. It was initial knowledge when I started apprenticeship, each of us made a toolbox with a little platoon of rivets marching around the joints to hold it all together  ;D

If it's not a blind hole (rivet sticks out the back where its hammered) then much simpler to remove and refinish separately I'd have thought. Could make a snap easily with the lathe to get right size. Doesn't have to be that tough for just four rivet, brass would do it to avoid any residual damage to rivet surface finish.

Navigation

[0] Message Index

[*] Previous page