SOHC.co.uk Forums > CB500/550

Kick start spindle

<< < (2/2)

Oddjob:
There is another circlip on the shaft, not as vital but maybe think about replacing that as well. Don't forget the large washer goes on between that circlip and the casing, a lot fit it wrongly or just forget.

Neill C:
All done and working thanks. Not an easy job doing it from underneath the bike on the side stand. I had to use a piece of fishing line to hold all the parts on as they just wanted to slide off the shaft!  I then fitted the circlip and pulled the line out once done. Thanks again

McCabe-Thiele (Ted):
Another amateur Gynaecologist strikes again.😎😎😎

Nurse Julie:

--- Quote from: Neill C on September 06, 2023, 07:01:42 PM ---All done and working thanks. Not an easy job doing it from underneath the bike on the side stand. I had to use a piece of fishing line to hold all the parts on as they just wanted to slide off the shaft!  I then fitted the circlip and pulled the line out once done. Thanks again

--- End quote ---
Very clever use of the fishing line, every toolbox / workshop should have a reel 👍👍👍👍

Trigger:

--- Quote from: Neill C on September 06, 2023, 07:01:42 PM ---All done and working thanks. Not an easy job doing it from underneath the bike on the side stand. I had to use a piece of fishing line to hold all the parts on as they just wanted to slide off the shaft!  I then fitted the circlip and pulled the line out once done. Thanks again

--- End quote ---

It is a tricky job but, doable. Well done  ;)

Navigation

[0] Message Index

[*] Previous page