SOHC.co.uk Forums > CB350/400
Swing Arm Grease Nipple
Trigger:
--- Quote from: Bryanj on September 06, 2023, 06:10:16 PM ---Sorry, never look at the header just read the posts!
--- End quote ---
Have you just awoken mate ;)
Bryanj:
Been doin stupid hours due to idiots closing the M5 mate
Oddjob:
Isn't that part just a normal size Matt? It's the same as the 550 swinging arm nipple and I'm sure I've replaced that with a stainless one before now. What thread pitch is it?
Trigger:
--- Quote from: Bryanj on September 06, 2023, 07:54:40 PM ---Been doin stupid hours due to idiots closing the M5 mate
--- End quote ---
I can not even remember the last time i was on a Motorway. As you know Bryan, not to many in Lincolnshire ;)
Matt_Harrington:
Ken, it's taper thread. It maybe M6 x 1 but I will check later when I unearth my nipple box (that just sounds wrong!) I have some identical S/steel ones but the thread is bigger so I was just contemplating modifying one .....Anyway, the old one is back where it belongs!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version