SOHC.co.uk Forums > CB350/400

Rubber repairs and electricity.

<< < (2/2)

Athame57:
Hi Ted
Thanks for this. As you can see from my first post I have found the parts I was looking for now. I was advised years ago to get them on this forum to get a cover, so there's a spot of chagrin about them holding water, my bike lives outside under a cover!  :(  I'm not sure there's anything I can do about that.

McCabe-Thiele (Ted):

--- Quote from: Athame57 on September 07, 2023, 10:10:29 AM ---Hi Ted
Thanks for this. As you can see from my first post I have found the parts I was looking for now. I was advised years ago to get them on this forum to get a cover, so there's a spot of chagrin about them holding water, my bike lives outside under a cover!  :(  I'm not sure there's anything I can do about that.

--- End quote ---

Out of interest for future reference where did you obtain your rubber from not many places seem to sell just the rubber mounting?

Athame57:
Same place as I've discovered other bits that are commercially extinct, from Steve at https://www.400fourbits.co.uk/   ;D

McCabe-Thiele (Ted):

--- Quote from: Athame57 on September 07, 2023, 10:59:49 AM ---Same place as I've discovered other bits that are commercially extinct, from Steve at https://www.400fourbits.co.uk/   ;D

--- End quote ---

Ah yes Steve he sold me some new steel ball bearings of the right size that fit on the triangular plate in the clutch mechanism. They seem almost impossible to find anywhere even the diameter seems to be hard to put a figure on.

Navigation

[0] Message Index

[*] Previous page