Other Stuff > Misc / Open

I suspect Ken is right about the quality of Gerben work look at my 500 carbs!

<< < (3/9) > >>

McCabe-Thiele (Ted):
Thanks Bryan tbh the photo using my phone  is a bit deceptive as the asymmetrical gap between the two holes makes it look bent but when you hold them together it looks reasonably straight.

I won't really know until it's taken apart - always wondered why they were not spot welded - not as many welding  robots  back then?

Bryanj:
Dont think they existed in the 70's

SteveD CB500K0:
Fiat Strada advert from 1979(?) as parodied by Not the Nine O’Clock News.

“Hand built by robots - driven by Italians”




Sent from my iPhone using Tapatalk

AshimotoK0:
I wasn't keen on the silver painted link plate and replated but knadgered JIS screws on mine.

Oddjob:
Maybe you'd prefer this look Ash?

I've only cleaned up the right side as the ceramic coaters left a lot of the metal unburnished, I was mucking about with some new polishing tools and used this as it is quite intricate and has hard to access areas. Left it like that so I could show it to the coaters in case they want to buy some of these new tools.



As this is the reverse it's the left side that's been done.

Navigation

[0] Message Index

[#] Next page

[*] Previous page