SOHC.co.uk Forums > SOHC Singles & Twins

My first project - 1974 CB360 K0

<< < (18/35) > >>

cbxman:
You might want check this out.  A bit of an upgrade.

http://www.sohc.co.uk/index.php/topic,30072.msg292298.html#msg292298

Hope the link works

Jerry

Craizeehair:

--- Quote from: cbxman on April 12, 2024, 08:33:58 AM ---You might want check this out.  A bit of an upgrade.

http://www.sohc.co.uk/index.php/topic,30072.msg292298.html#msg292298

Hope the link works

Jerry

--- End quote ---
Thank you Jerry,

I’ll have a good read of that later, much appreciated.

Greg

Craizeehair:
I’ve put a few things back on the frame, the swinging arm with new bushes and lower shock bushes, centre stand, handlebars, top and bottom yokes with new tapered roller bearings and rebuilt front forks.

The wiring harness has been cleaned in the ultrasonic and I’ll attempt to fit that next, once it has dried. After that I plan to replace the wheel bearings and brake shoes, front and back then get the wheels back on to make it easier to move around again.

McCabe-Thiele (Ted):
Even though you might have used an Ultrasonic Bath to clean your loom. I would still use Cillit Bang Limescale Remover on the connections as per NJ's advice on previous posts.

Craizeehair:
Thanks Ted, I will do that before it goes back on.

Navigation

[0] Message Index

[#] Next page

[*] Previous page