SOHC.co.uk Forums > Project Board
Project CB350F
magpie114:
The caliper pivot pin is fine and the hose is new. I think your suggestion about the fine hole is most likely. Thanks, I’ll investigate that further.
Sent from my iPhone using Tapatalk
Bryanj:
Down and dirty test is carefully cover everything arround the master then remove cap and diaphragm pull in lever and let go and if hole is clear you should get a small fountain( hence the coverings!)
magpie114:
All sorted thanks, exactly as you described. Took a little while and some patience but unblocked it with wire strand and got a fountain. Fortunately silicone fluid but covered everything anyway. Thanks Alan
Sent from my iPhone using Tapatalk
Laverda Dave:
Great photo Alan. You must be very pleased how the bike turned out 8). Good news with the brake, great piece of diagnoses Bryan and you didn't even have to see it to know what the problem was, experience you cannot buy👍
Bryanj:
After crud behind caliper seal its the most overlooked problem, as you said been doing Hondas now close on 50 years so seen quite a lot of obscure problems
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version