SOHC.co.uk Forums > Project Board
Project CB350F
taysidedragon:
The paintwork is beautiful. Lovely job. 👍
Orcade-Ian:
The paint looks excellent Alan,
As you say - Velo like! You certainly seem to be on the home straight now, very encouraging when it's reassembly and no more cleaning or removing obstinate bolts!
I've been out on mine recently but had an issue with what appeared to be fuel starvation when asking for a bit more gas on uphill bits. Hopefully found the culprit with a lot of fine particles on the top of that really fine brass filter screen in the tap bowl and a small piece of leaf (how the hell did that get in there?) when I drained and flushed the tank. Glad I didn't go to the Crieff meeting on it.
Might get out in the next day or so to see if I've cracked it!
Ian
Nurse Julie:
Remove the paint on the seat with nail varnish remover and re do with a stencil from Piki (I may have a spare here come to think of it) and TRG spray vinyl paint.
magpie114:
I wondered if there was solvent which would remove it. I’ll try give it a go.
Sent from my iPhone using Tapatalk
Laverda Dave:
The paintwork looks very good, not long to go now👍.
I painted the HONDA logo on the back of my new seat today using the stencil and the TRG paint and it's an absolute mess! The paint has bleed into the grain of the vinyl over the whole seat, I'm going to have to use a bottle of varnish remover to get it off. I really don't think I'll bother trying to paint it again (I don't have another stencil for starters) and the chances are it will do the same again. I went over the stencil with a roller to make sure it was properly stuck down but it obviously can't get into the grain of the vinyl to seal it and the paint being thin bleeds into it.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version