SOHC.co.uk Forums > CB500/550
It’s home at last!
McCabe-Thiele (Ted):
--- Quote from: Sesman on December 26, 2023, 12:37:39 PM ---And that is not a challenge, Ted😁😁
--- End quote ---
Seasonal reply.
Oh yes it is, - oh no it isn't.
Acknowledgement: - Pantomime Dame.
Sesman:
He, he😁👍
Bryanj:
Ho Ho
Oddjob:
Sorry to correct Bryan but do not try to lever the cover off, you will distort it doing that unless the spring clips are rusted through. Remove the housing from the engine, look inside and you can see the other ends of the pins, the holes aren’t blind, get a pin punch or a long thin nail and you can knock them out from the inside, do a little on each one first, just to loosen them off.
I’ve repaired far worse than that cover, the dent can be knock out from the back but a shot bag is needed ideally. The rest can be just blended in.
Johnny4428:
Thanks I was wondering how these were attached and how to remove them. I will of course have a bash at restoring.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version