SOHC.co.uk Forums > The Black Bomber Board
M10 DOME Cylinder NUTS HEX
mo goldie:
Hi Ashley
yes looked at dave silvers and they did Not have them.....so I did go to CMS and have ordered them from there and with that part Number of 52108-283-300 too so hope they are right. Julie just got back to say she can`t get any for the CB450K0, so went CMS to try as said.................. as everyone all seemed to not have things now... I wonder why lol.
so hope you got all paypal payments now ?
cheers Mo
oh that shaft is tight in there I have tried hitting it but don't want to damage the threads on the Nut or sharft....is it meant to be that tight ? :(
AshimotoK0:
Bomber 283 parts NOS are extremely rare. After all they stopped making them in 1967. All payments received and sent this morning signed for delivery. If you mean the bolt that goes through the sleeve . It shouldn't be tight but after 55 plus years who knows.Could be some corrosion set in.
mo goldie:
Hi Ash thanks for that.
and yes I do mean the the long bolt that go`s though the collar and it was meant to have all been restored so should not be any corrosion but who knows till I get it all apart to look. but if it was done like I was told the swing arm would Not have play in it .... so I am glad that i am doing all the work Myself to get it right...... then if there is a problem blame me ha ;D
well that's what I have done to all my bikes is had to strip them down to carry out work that has been done by some one else :-X
AshimotoK0:
Can you turn the hex on the bolt? If so try getting somebody to turn it whilst hitting the other end. If there is a grease nipple on the threaded end either pull it out or use a tube or bar with hole drilled in the end to avoid crushing the nipple. Bit awkward applying heat as I guess the paintwork has been restored.
Just checked and cant see nipple at the threaded end. You could put nut on wrong way round partially and hit the flat face to get it started
mo goldie:
yes hex turns on the right hand side where the Grease nipple is..so No hex on threaded side but i have now tried to turn the hex and hit it from the other side so think it will come out with an bit of help..... so Hope I will do that over the next week or so,,,,,,,,,,,,, as got to get parts first lol
Oh forgot to say Ash.............. I canceled the parts from CMS and done what you said and got them from Dave silvers but have to wait a couple of weeks they said to get them in but all were cheaper Than CMS too and I got some more parts extra too. 8)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version