Other Stuff > Misc / Open
Cruzinimage pistons and rings
K2-K6:
--- Quote from: Laverda Dave on November 09, 2023, 10:40:21 AM ---That's a bit worrying considering I was going to buy a set for the rat bike rebore! Are there any other makes apart from Honda? I think I used an IMD(?) Piston kit in the 250RSA, hopefully they do a set for the 400/4. Do Cruzinimage makes pistons and rings for anyone else?
--- End quote ---
Possibility https://www.ebay.co.uk/itm/255571788913 but a little pricey.
Seems to be only pistons, but 6 available https://www.ebay.co.uk/itm/285149322144
Both sets 0.25mm over sized.
DomP:
Oh I'm loving reading this thread!
paul G:
Never had any issues with mine and the 400/4 gets some hammer as anyone who has one will know, you have to keep them buzzing ;D
Nurse Julie:
--- Quote from: DomP on November 09, 2023, 11:24:37 AM ---Oh I'm loving reading this thread!
--- End quote ---
I think it's an interesting thread Dom. There are lots of forum members that have Cruzinimage piston / ring kits fitted by Graham after engine builds and re bores , so it will be good to hear if they have had any issues they haven't told us about. My own personal experience is that they are a good piston / ring kit and I do a lot of miles on my bikes, if there was an issue, it would have presented itself by now.
Laverda Dave:
--- Quote from: K2-K6 on November 09, 2023, 10:57:46 AM ---
--- Quote from: Laverda Dave on November 09, 2023, 10:40:21 AM ---That's a bit worrying considering I was going to buy a set for the rat bike rebore! Are there any other makes apart from Honda? I think I used an IMD(?) Piston kit in the 250RSA, hopefully they do a set for the 400/4. Do Cruzinimage makes pistons and rings for anyone else?
--- End quote ---
Possibility https://www.ebay.co.uk/itm/255571788913 but a little pricey.
Seems to be only pistons, but 6 available https://www.ebay.co.uk/itm/285149322144
Both sets 0.25mm over sized.
--- End quote ---
Gez, reassuringly expensive as they say🥴. Thanks for the tip Nigel, I might well go the original route but interesting comment from Julie about the ring manufacturer. I've yet to measure the bores but I do know the original pistons are in there and the bike has done 46,000! I remember the magazines in the 70’s say Jap bikes wear out due to the high revs, I don't think so🙂
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version