SOHC.co.uk Forums > CB350/400

Rear mudguard/fender wiring harness.

<< < (2/6) > >>

Bradders:
Thanks for the info Ted. How do I tell what gauge/ ampage I need and I’m embarrassed to say I don’t know how to solder!

philward:
This may help too
https://www.ebay.co.uk/itm/152873651204

McCabe-Thiele (Ted):
I always tend to have my wiring on the heavier than needed side so I tend to use use multi stranded copper wire either 0.75 or 1.0 though you can safely go thinner as the ampage is low even lower if you fit LED bulbs.

Important thing with soldering  is cleanliness, I still use leaded multicore solder - these days its lead free I believe. Lots on Utube  on how to solder -easy to practice first until you learn how much solder you need to feed into a closed joint. I use a solder gun rather than an Iron it's personal choice though I have both.

I use a small multi jointed work stand with clips on to hold everything in place to avoid burns - like this mine is decades old

https://cpc.farnell.com/pro-s-kit/608-391b/helping-hand-system/dp/TL01327?mckv=s_dc|pcrid|224654335881|kword||match||plid||slid||product|TL01327|pgrid|50784539401|ptaid|pla-1680367460111|&CMP=KNC-GUK-CPC-SHOPPING-945678466-50784539401-TL01327&s_kwcid=AL!5616!3!224654335881!!!network}!1680367460111!&gclid=CjwKCAiAx_GqBhBQEiwAlDNAZiIsVAfbCLimEsjNJ86-O1GNCdrFb5uEd_9qkf9ELKFCSWsVXTYMMxoCttcQAvD_BwE

Oddjob:
There's always this.

https://www.cmsnl.com/honda-cb500k1-four-england_model14660/cord-tail-light-non_33711300000p/

500 should work in a 400 I reckon.

Bradders:
Thanks Oddjob, I shall try to contact them to check if it fits.

Navigation

[0] Message Index

[#] Next page

[*] Previous page