SOHC.co.uk Forums > The Black Bomber Board
Timing problems on the 450 Bomber
royhall:
I would temporarily go back to points anyway. That way you can prove the bike's systems are correct thus possibly proving the EI is faulty. Bit of a pain with yours as they had you cut off some connectors. Why they can't provide cables already fitted with the correct connectors is beyond me. Pretty poor really, making you basically butcher the harness. If you then should find a fault on the bike you can rectify that then refit the EI later on, this time using the correct connectors instead of those horrible screw up things
Sent from my Pixel 7 Pro using Tapatalk
mo goldie:
Hi well some news they got back to me and things might be on the UP.....
as they asked me to try a few things which was to strip the wires back a bit and make sure they have got connection which I had done before anyway but ha ho give it a try again ha ( did Not make any thing new ) and asked if the Led light`s were going on and off when you rotate the engine which they do so rule out the sensors Then, so when i told them they said they can sort something out under warranty .. Yahoo ............ getting somewhere............ so have to wait for them to get back and see if they going to send out some new modules if so up to 3 weeks I bet ha but as its cold and the bike wont be going out till spring No rush :(
Oh i will try that out Roy about the points too and I have Not had to butcher the wiring as them just tap into the wire still Not good tho ........ but when its all ( I Hope Up and running ) I will change out the connection's for ones like the block connectors and do a proper job ha.
Bryanj:
Sounds like you may be getting somewhere
mo goldie:
Hi All been trying to rewire the points back in and blow two fuses :-\
can someone have a look at the pictures and tell me what go`s with what wires and what needs to be linked please.
I will start off with the coil wires there is on the left coil one black/white and one blue. right coil one Black/white and one yellow so where do they go to...... keep it simple please LOL :'( then there is the condensers a yellow and Blue now where do they go ?. then you have the two wires from the points one yellow I think left point and the blue the right point so where do they get linked too ?
I want to prove that all ok with the points so when the Common Motor`s get back i can say it works ok with points well I hope ha .
as I say keep it simple as Not up much on this..... should have took a picture of that before I tried to instal the Electronic ign ...Hind sight ha, but you think it was going to be a fit and forget ...well I did anyway ;D
cheers Mo
royhall:
The condenser's on these should have a bracket that fits onto the coil mounts.
Not a good picture but you can just see the condenser on top with its two screw bracket. Looks like it's already fitted to yours. Are they the new coils?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version