SOHC.co.uk Forums > CB750

David Silver Daytona Electronic Ignition Kit

(1/2) > >>

stoutgoose:
Hello all. Before I go back to Silver’s and ask for clarification, has anyone else fitted the Daytona ignition kit? The reason I ask is that it states in the instructions that on set up, you should connect the black wire to the rear brake switch feed. I’m assuming this is to provide a 12v earthed supply.
However it didn’t state whether this needs to be disconnected and then connected to an earth or something else.
Any ideas?

McCabe-Thiele (Ted):
Not sure what you mean by a 12 volt earthed supply?

Reads like an oxymoron.

royhall:
Black on old Honda's is switched live.

Sent from my Pixel 7 Pro using Tapatalk

Bryanj:
It is a 12v pos dc supply to the electronic bits, the earth is via the plate and crankcase

stoutgoose:
Excellent! Many thanks.
The blue and yellow wires from the ignition plate route to each of the coils; I assume there is a 12v supply running from the kill switch to the other side of each coil?
The reason I ask is that I need to build a loom from scratch for a track bike using a basic wiring circuit. No lights, starter, etc.

Navigation

[0] Message Index

[#] Next page