SOHC.co.uk Forums > CB350/400

Primary shaft removal.

(1/2) > >>

Dolomite_:
Im currently stripping the engine and following the haynes manual for it. Ive been trying to remove the primary shaft but it feels like the nut needs a hell of a lot of force to undo.

Is there a way to hold it in place? I've still got the pistons connected and it seems like they're holding it in place when I try to undo it.

Whats the best way to undo the bolt holding the primary shaft in?

Bryanj:
Put the clutch back on and a penny in the teeth

K2-K6:

--- Quote from: Bryanj on January 08, 2024, 10:53:25 PM ---Put the clutch back on and a penny in the teeth

--- End quote ---

Oooooh....have you seen the price of a new penny nowadays  :o

https://www.ebay.co.uk/itm/186006858870 an early one here.

Johnny4428:
Good tip Bryan with the penny! And that one looks as if it has been in about a few clutch teeth Nigel! Take it that’s a typing error on the price?

Bryanj:
If you cant afford the penny, and i couldnt. A copper washer or even alloy will do, just when i was in workshop as most lazy maniacscdid just put hand in pocket

Navigation

[0] Message Index

[#] Next page