SOHC.co.uk Forums > The Black Bomber Board
67` Bomber running problems
Bryanj:
Honda always list alternate sprockets but they were designed with a ratio and yes, compared to british iron, they do seem to rev high BUT its higher up the rev band they give rated power, the 500 handbook says not to go out of the top of the red too often
AshimotoK0:
Cursing you today Mo ... 'cos I had to go to the bowels of my stash to find this to measure for you. ;D ;D ;D
4 mount holes around 9.7 mm Dia. Large centre hole 73.7 mm Dia.
[ Guests cannot view attachments ]
mo goldie:
are thanks Ash........ well its Not just the mrs then that I upset LOL
so I have sent that off to the bloke .... I hope he will find a sprocket that will fit with them Dimensions.
so thanks Again Ash to the rescue ;D or should I say MR Honda ;D
AshimotoK0:
--- Quote from: mo goldie on May 19, 2024, 07:19:03 PM ---are thanks Ash........ well its Not just the mrs then that I upset LOL
so I have sent that off to the bloke .... I hope he will find a sprocket that will fit with them Dimensions.
so thanks Again Ash to the rescue ;D or should I say MR Honda ;D
--- End quote ---
Well it went OK 'cos I found a NOS one in there for my own Bomber I wasn't aware I had and didn't realise they are so rare !
mo goldie:
are goodo then Ash I was some use ha......... pity you did Not Have two ha :(
that would have made it all the more worth while ;D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version