Rev counter blank

[DomP]

https://www.ebay.co.uk/itm/204061144662?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=-JvW0lVRTvK&sssrc=4429486&ssuid=Y0YDXM_4R0-&var=&widget_ver=artemis&media=COPY

Whats the chances this fits a cb550?

[Johnwebley]

Extremely doubtful

Sent from my SM-A546E using Tapatalk

[DomP]

Extremely doubtful

Sent from my SM-A546E using Tapatalk

I'm ever the optimist!

[Johnwebley]

Couldn't you cut a piece of 6mm alloy to shape, drill for the screw,

Make a gasket, and fit??

Or you could buy a sheet of carbon fibre, the sort that is used for models,



Sent from my SM-A546E using Tapatalk

[DomP]

Couldn't you cut a piece of 6mm alloy to shape, drill for the screw,

Make a gasket, and fit??

Or you could buy a sheet of carbon fibre, the sort that is used for models,



Sent from my SM-A546E using Tapatalk

I thought it might need an insert with an oring to seal but you are probably right, certainly worth trying

[Bryanj]

Just leave the cable off but fit the drive housing, there is an oil seal in there

[DomP]

Just leave the cable off but fit the drive housing, there is an oil seal in there

Good point Bryan!

[Bryanj]

With the drive gear of course!

[Laverdaroo]

I don’t understand the sizing of that so don’t really know Dom, somebody with far superior marbles will probably be along shortly to tell you. It’s a bit dear at nearly 30 quid though.

This is similar to what I used and it’s a dead tight fit so not coming out, think I had to tap it in with a block of wood to get it in right but fits a treat for less than 10 bob


Sent from my iPhone using Tapatalk