SOHC.co.uk Forums > CB350/400
Anyone recognise this bit?
McCabe-Thiele (Ted):
Might not be a 0.22 how about a 0.177.🤔🤔🤔
Laverdaroo:
Well if it is, it left no mark Ted
Sent from my iPhone using Tapatalk
ozzybud:
i just had my carbs apart to adjust the needle height it is a part of the internal linkage in the diagram under #9. on the left side of the 9 box area it is the third bit down from the top. it slides up into the screw.. without it i would think getting the carbs in sync would be very difficult... I was very amazed how many pieces there were inside the carbs just for the linkage. Honda had some amazing engineering going on but this assembly is complex to say the least.
davidcumbria:
You can see it 3 min and 13 sec in this video
https://youtu.be/wFaFIsYXiPc?si=R4AT1defc8MSov1N
McCabe-Thiele (Ted):
Well spotted Ozzybud I did not realise they come out!
Knowing your luck Roo it will be the last one you check that's missing!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version