SOHC.co.uk Forums > Project Board
Mike's CB550 Project
DomP:
That's true Mike, also all new carb o rings from Julie here too.
Mike_Berkshire:
Thanks all for the help. I stripped and cleaned the carbs paying particular attention to the idle circuits giving it a good squirt through with carb cleaner, blowing out the residue and leaving overnight to evaporate away thoroughly. I rebuilt the carbs this morning with the new idle jets (thanks Julie, I forgot I had bought them but not fitted them!) and checked and adjusted the float heights - a couple were out by 1.5 - 2.0 mm. I re-synched the carbs; this time I set all sliders at the just opening position; previously I had set at a bigger gap. I fitted 2 of the in-line Aeroline filters (thanks Ted for the photos).
The bike ran much better and I have just got back from a blast up and down the road - about 5 or 6 miles; flipping cold but very satisfying :-)
There is still a slight hang now and then but nothing like it was; the bike hesitates when pulling away from a standstill and needs quite a lot of revs. Its been years since I rode a 4 cylinder bike so partly the 'hesitation' might be that I am more used to big twins with low-end torque? The bike still smells as if it running rich.
All in all a pretty good mornings work though
JamesH:
Mike - not sure if this is a red herring, but I've had a 'slow to return to idle' situation on a couple of bikes in the past; both occasions turned out to be a 'sticky' ignition mechanical advance/retard mechanism. Have you cleaned/lubricated the advance/retard cam that sits behind the points plate?
Oddjob:
I should have said to do this but TBH I sometimes presume that people know things when they don't. I always recommend when setting float heights to actually check the fuel is being shut off when the float reaches the required height. To do this you need to leave the float bowl off, connect a fuel feed somehow, maybe even connect to the tank and do it by the side of the bike. Then using the same float gauge you used to set the float lift the float up whilst the petrol is turned on, a small bowl under the carb is recommended to catch the petrol. Slowly lift the float using the gauge and it should stop the fuel when it reaches 22mm or whatever the fuel level is on your particular bike. Do this for all 4 carbs. At least that way you are making sure the fuel is actually being shut off and can avoid yet another carb demount because it isn't a lot of the time. Clean the float pin, polish it if needed, make sure the float moves easily. Check to see the pin isn't bent.
Good shout on the advancer James, always worth a check.
I'm not over keen on bench syncing carbs TBH, most times people set the gap too big and wonder why the bikes revving it's nuts off, hence why I asked if you had gauges, I prefer to set mine so as you just move the butterfly you can see a really small gap at the bottom on all 4 slides, you can then lift them all the same amount with the idle screw on the bank if required. With gauges you can get them spot on after fitting.
Mike_Berkshire:
I don’t have gauges but now the bike is running reasonably well I can set the timing using a strobe light and get someone with vacuum gauges to accurately set the carbs up.
I have previously checked the advance mechanism and it was fine.
I set the carbs so that as you say the sliders are just opening-vacuum gauges should enable me to fine tune from there?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version