SOHC.co.uk Forums > CB350/400

Transmission output shaft bearing removal

<< < (2/3) > >>

McCabe-Thiele (Ted):
If you mean the part of the shaft where the oil seal sits I'm pretty sure the bearing will come off - just dont heat it and destroy the O ring.

Dolomite_:

--- Quote from: McCabe-Thiele (Ted) on May 26, 2024, 06:39:58 PM ---If you mean the part of the shaft where the oil seal sits I'm pretty sure the bearing will come off - just dont heat it and destroy the O ring.

--- End quote ---

Ill have to dig my vice out from the garage. I didn't think of clamping the bearing. I didn't want to damage it too much but I think that's the only way.

McCabe-Thiele (Ted):
Might be worth a PM to Laverda Dave he did a 400 gearbox rebuild earlier this year.

Dolomite_:
The shop manual doesnt show a seal between the collar and bearing/bearing and sprocket.

Dolomite_:
I've tried heating the collar, clamping the bearing and giving the shaft a wack. Not budging at all.

There does seem to be a seal between the bearing and collar. There is no way to remove the gear, the groves are too big for it to slide off the other way, the bearing and collar are holding it on.

Navigation

[0] Message Index

[#] Next page

[*] Previous page