SOHC.co.uk Forums > CB350/400
Transmission countershaft 25mm lock washer fitment
McCabe-Thiele (Ted):
The flat washer sits in the middle between the gear and the tanged one, I feel certain as per the parts book with the tangs towards the gear.
Where those grooves are on the shaft enables you to rotate the flat washer until you find the right position for the tanged part to engage into the correct position.
It's almost as if there is a master position between the flat washer and the tanged one that has to "fit" so it fits up to the gear correctly.
Hopefully someone else can step in here to assist you.
Dolomite_:
This is the only way they sit flush as far as a I can tell.
McCabe-Thiele (Ted):
That might be right but it contradicts the photo in the parts book so I would wait for someone else to chip in.
I've checked my 400 project but not shown. I will take a look at more of my original 400 photos.
Dolomite_:
The haynes manual shows this
McCabe-Thiele (Ted):
Yes that's like the parts book and as I remember it but initially it just did not want to sit right but after a lot of rotating it at the slotted section it eventually fitted!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version