SOHC.co.uk Forums > CB350/400

Crankcase starter gear shaft entry hole.

(1/2) > >>

Dolomite_:
Bit of a brain fart, and I cant quite tell from the pictures I took. In the picture, the hole where the starter gear shaft is inserted, what covers it up? is there a bung or does something else go in there?

Deano400:
You say "In the picture", did you intend to attach a picture?

Dolomite_:

--- Quote from: Deano400 on June 05, 2024, 06:19:23 PM ---You say "In the picture", did you intend to attach a picture?

--- End quote ---

Now there's a picture, the link didn't work for some reason

Laverda Dave:
No, nothing else goes in there. The shaft is retained by a 6mm bolt and a lock washer, make 100% sure you replace the lock washer otherwise the shaft retaining bolt may escape if it comes loose and drop into the gearbox.

Dolomite_:

--- Quote from: Laverda Dave on June 05, 2024, 06:58:13 PM ---No, nothing else goes in there. The shaft is retained by a 6mm bolt and a lock washer, make 100% sure you replace the lock washer otherwise the shaft retaining bolt may escape if it comes loose and drop into the gearbox.

--- End quote ---

So nothing closes up that access hole? I'm surprised oil doesn't make its way out.

Navigation

[0] Message Index

[#] Next page