SOHC.co.uk Forums > CB350/400

Trying my hand at balancing the carbs....not going amazingly well...

<< < (2/2)

McCabe-Thiele (Ted):
Did you start off with a good bench synch?
My 400 runs fine on a bench sync only.
I did mine using a very small drill bit shaft - it was an odd sized drill 3/32 iirc.
Using a gauge will not improve results if there is any air getting onto the intake system between cylinder hard and carbs.

I favour the smaller gap on the sliders - in my head it reduces any hanging idle issues.

Navigation

[0] Message Index

[*] Previous page