SOHC.co.uk Forums > CB350/400
Silencer to collector box gasket.
Eldrick:
--- Quote from: Dolomite_ on June 23, 2024, 04:20:02 PM ---
--- Quote from: Eldrick on June 23, 2024, 04:15:57 PM ---I have the same issue with the Brituro silencer, I had to widen the end of it to make the gasket fit in and even then it has deformed the gasket.
--- End quote ---
Did you manage to get in on properly without it splitting?
--- End quote ---
Not yet, I have to put the cylinderblock and rocker cover back on the bike first.
Nurse Julie:
I shaved the gasket down with a few razor blade to make it fit.
Eldrick:
I'm politley asking DS about this and referencing this thread. Maybe it is something that needs attention in manufacturing.
Nurse Julie:
--- Quote from: Eldrick on June 24, 2024, 07:10:34 PM ---I'm politley asking DS about this and referencing this thread. Maybe it is something that needs attention in manufacturing.
--- End quote ---
I think DS has been told about this numerous times but the reply was along the lines of 'oh well, never mind' 🙄🙄🙄🙄
Eldrick:
--- Quote from: Nurse Julie on June 24, 2024, 07:24:35 PM ---
--- Quote from: Eldrick on June 24, 2024, 07:10:34 PM ---I'm politley asking DS about this and referencing this thread. Maybe it is something that needs attention in manufacturing.
--- End quote ---
I think DS has been told about this numerous times but the reply was along the lines of 'oh well, never mind' 🙄🙄🙄🙄
--- End quote ---
Then maybe my wallet will mind next time I need parts...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version