SOHC.co.uk Forums > CB350/400

Damaged rear wheel washer and circlip - replacement part

(1/3) > >>

beemsquar:
Good evening all,

On inspection of my bike I've noticed the the rear wheel washer and circlip have been mangled somehow and are now no longer usable. They are parts 2 and 16 in the Haynes manual and I'm struggling to attach a image.
I don't have a sprocket cover and I'm running an aftermarket sprocket anyway. I also don't have item 18, locking washers and wonder if that's what's caused the problem?
I bought the bike a while ago and am learning as I go. Can someone tell me if the circlip attaches to the bearing retaining ring, or what the purpose of the 3 parts above is, as I can't see what they are holding on or spacing.

As far as I can see, these parts aren't available from David Silver Spares or CMSL.

Any help would be really appreciated.

Also is this safe to ride 10 miles to the garage?

Many thanks.

Deano400:
Steve at 400fourbits has the washer and circlip.

https://www.400fourbits.co.uk/#running

Deano400:
Has the chain been off in the past and damaged them?

beemsquar:
Amazing, thanks for the reply. The bike was restored about 8 years ago, so was completely stripped down.
What are those parts holding on? I see no groove in the bearing cover plate for the circlip to slot into.

Would I need the  2 locking washers also?

Thanks

Deano400:
The groove is on the hub, the washer and circlip hold the sprocket on. IIRC the two locking washers weren't installed originally. Someone on here may know better.

Navigation

[0] Message Index

[#] Next page